Discontinued product, the replacement product is I2C-IN830M0V2.
*
The RoHS icon with this product means the PCBs, components, solder, chemicals are all lead-free and RoHS compliant. And this product is produced in lead free process. Unfortunately, now, we cannot provide documentation for this product is RoHS compliant.
Resources:
*
If your browser program can't show a pdf file on a screen completely, please save it into your computer and open it with a pdf reader program.
Package Includes:
This package does not include Din-Rail PCB holders and cables.
Notes:
- This package does not include Din-Rail PCB holders and cables.
- This board uses 5-pin connectors for I2C bus.
Features:
- PCF8574 I2C chips
- Support 100kHz I2C bus frequency
- On-board I2C bus pull-up resistors
- Address by 3 jumpers for use of up to 8 addresses
- Up to 16 boards on a bus, (use with I2C-IN830MA)
- Interrupt output signal
- On-board interrupt pull-up resistor
- Compatible with most microcontrollers
- 8 Optically isolated digital input channels
- 15-30VDC input voltage
- 3700VDC isolation input voltage
- Operating power supply voltage 3.3-5.5VDC
- Inverse polarity protection circuits
- DIN-rail supports
- PCB size 42.50x72.00mm
This is 8-channel opto-isolator board for input expander over I2C bus. Each input accepts 15-30VDC. It is suitable for mechanical contact switching devices such as relay switches, push-buttons and switches. The board uses PCF8574 I2C chip. It supports 100KHz bus speed and 3.3-5.5VDC bus voltage. The board has three jumpers for setting an own address. So boards can be connected up to 16 boards on a bus. Also there are I2C bus pull-up resistors and interrupt pull-up resistor on board. They can be enabled by jumpers.
The board can be placed on DIN rail PCB holder which can be plugged on a tray.
The difference between I2C-IN830M and I2C-IN830MA is I2C chip. The I2C-IN830M uses PCF8574 but the I2C-IN830MA uses PCF8574A. And the difference between PCF8574 and PCF8574A is I2C bus address.
To prevent damage to the board. Don't plug and/or unplug I2C cables on the board while a power supply still turns on. Turn off a power supply before plug and/or unplug I2C cables on the board.
